Perguntas Sem válvula de prioridade
Re: Sem válvula de prioridade
19/07/2016 às 22:07
O Texto foi melhorado, deve ser devido aos turbos com rolamentos que devem gerar alta pressão de turbo! Segue o texto novo! De qualquer forma este novo texto também diz que por longo períodos (compressor gerando mais volume de ar do que o motor pode admitir) e também diz que se for muito forte o surge pode danificar os rolamentos do turbo, agora o que é forte e quanto de pressão de turbo é necessário usar para causar danos aos "rolamentos" não foi divulgado, vai ver as roletadas quebraram os rolamentos ou algo do tipo e revisaram o texto, no texto antigo se aprofundava muito mais sobre o assunto, eu deveria ter guardado!
What is compressor surge?
A. The surge region, located on the left-hand side of the compressor map (known as the surge line), is an area of flow instability typically caused by compressor inducer stall. The turbo should be sized so that the engine does not operate in the surge range. When turbochargers operate in surge for long periods of time, bearing failures may occur. When referencing a compressor map, the surge line is the line bordering the islands on their far left side. Compressor surge is when the air pressure after the compressor is actually higher than what the compressor itself can physically maintain. This condition causes the airflow in the compressor wheel to back up, build pressure, and sometimes stall. In cases of extreme surge, the thrust bearings of the turbo can be destroyed, and will sometimes even lead to mechanical failure of the compressor wheel itself. Common conditions that result in compressor surge on turbocharger gasoline engines are:
-A compressor bypass valve is not integrated into the intake plumbing between the compressor outlet and throttle body
-The outlet plumbing for the bypass valve is too small or restrictive
-The turbo is too big for the application
What is compressor surge?
A. The surge region, located on the left-hand side of the compressor map (known as the surge line), is an area of flow instability typically caused by compressor inducer stall. The turbo should be sized so that the engine does not operate in the surge range. When turbochargers operate in surge for long periods of time, bearing failures may occur. When referencing a compressor map, the surge line is the line bordering the islands on their far left side. Compressor surge is when the air pressure after the compressor is actually higher than what the compressor itself can physically maintain. This condition causes the airflow in the compressor wheel to back up, build pressure, and sometimes stall. In cases of extreme surge, the thrust bearings of the turbo can be destroyed, and will sometimes even lead to mechanical failure of the compressor wheel itself. Common conditions that result in compressor surge on turbocharger gasoline engines are:
-A compressor bypass valve is not integrated into the intake plumbing between the compressor outlet and throttle body
-The outlet plumbing for the bypass valve is too small or restrictive
-The turbo is too big for the application
*Gol G4 AP 1.6 Turbo
*Honda Civic SI Black 08/08 100% stock
*Honda Civic SI Black 08/08 100% stock
Por favor Entrar ou Registrar para participar da conversa.
Re: Sem válvula de prioridade
20/07/2016 às 17:27O esmerilhador escreveu: NÃO ACONTECE NADA COM O TURBO ANDAR SEM PRIORIDADE!
Segundo o material técnico do site turbobygarret informa que existem dois tipos de surge, o surge temporário e o contínuo!
O surge temporário ocorre com a ausência da válvula, como o golpe sofrido pelo turbo por apenas (ms) milissegundos (tempo que você vê o seu manômetro de pressão de turbo voltar à 0 ao tirar o pé do acelerador) é insuficiente para causar qualquer dano ao turbo.
O contínuo acontece quando o compressor do turbo gera um volume de ar tão grande que o motor é incapaz de admitir (mesmo em wot) e este de forma contínua retorna pela boca da turbina que causa desgaste do turbo reduzindo muito a sua vida útil.
Eu não uso prioridade desde 2004.
E como fica a questão do LAG, vc acha que aumenta? E o punta taco, dá pra fazer?
Chevette 1975'
Por favor Entrar ou Registrar para participar da conversa.